Here's a VERY easy way of makin' meth. My friends say this METHod works, I've seen the end product and it seems to be meth although I haven't tried it. Here's how to make it.

The chemicals you'll need:


Ephedrine/Pseudoephedrine.
Iodine.
Red phosphorus.
Ether.
Hydrochloric Acid.
Sodium hydroxide.
Methanol.

Equipment you'll need:


3 Plastic jars with lids.
Coffee filters.
Eyedropper.
Glass dish.
Funnel.

Here's how to extract the ephedrine/pseudoephedrine:


Firstly the pills are washed with acetone (we use ether) to remove the red colour.
Crush your pills and put them in a jar.
Add the methanol and fit with lid. Shake jar hard for approx. 15 minutes.
Leave it to settle and your pseudoephedrine will be dissolved in the alcohol while the waxes and fillers will settle to the bottom.
Carefully pour the top layer into a funnel with coffee filter and onto a glass dish.
Evaporate the alcohol (gentle heat and/or hair dryer.) And you'll be left with pseudoephedrine.

METHod:


Add the Ephedrine/Pseudoephedrine to iodine, red phosphorus and hydrochloric acid in a jar. And fit with lid. Shake it for approx. 20-30 mins. Then leave it to settle for approx. 15-20 mins.
Add sodium hydroxide to the ephedrine/pseudoephedrine mix, fit with the lid and was gently shake. repeat this step until the mixture remains cloudy. (fit the lid after the sodium hydroxide had stopped reacting).
Add ether to the Ephedrine/Pseudoephedrine mix, fit the lid and shake for approx. 8 mins.
Leave the mixture to settle for approx. 5 mins and a thick middle layer can be seen, tap the side of the jar to get this layer a thin as possible.
Remove the top layer using an eyedropper making sure not to get any of the middle in there. save the top layer and throw the rest away.
Fill another jar half-way with water, and add about 10 drops of acid. Add the saved top layer to this, fit the lid and shake for approx. 3 mins.
Once the mix has settled remove the top layer and throw it away, keeping the bottom layer.
Evaporate the bottom layer and the remaining crystals are methamphetamine.

I've got all the parts but arent sure if it would be a waste or not

The rxn is bunk,and dangerous to boot, the reaction requires a total lack of oxygen, and as soon as it started your sealed container would explode, and new ephedrine pills are full of povidone and other gunk, so a straight alchohol wash will not work. Rhodium is a good place for this type of stuff.

[This message has been edited by culinaryoverlord (edited 10-15-2002).]

[This message has been edited by culinaryoverlord (edited 10-15-2002).]

IF the rxn is bunk, and the sealed container will explode with this method. Will the push-pull method work as described on the chemhead site?

Manufacturers now put povidone and polyethylene glycol in the pills to foil home chemists' attempts at extracting pseudephedrine from their products. An alcohol extraction alone will not work.

Yes the P/P method on chemhead will work, if swiu is a newbee, Kiwi suggests that swiu us the Old Acidmelt.