this probanly belongs in another post
i was wondering if any of u regular here cold tell me if this is possible without flamm me.can u make a smoke bomb that when it runs out of smkoe blows up like a small explosive or something?

Sure. I'll assume you already have your explosive and smoke compound.

Simply embed the fuse from the explosive (Cratermaker, M-80, or what have you) in the end of your smoke compound. Light the smoke compound from the side opposite the explosive, and you're all set.

code:

---

  ===================================
     ###############  |-----------|
-----### Smoke ####---- Explosive |
     ###############  |-----------|
  ===================================

---

~Zero

I sometimes use just a smoke bomb as a fuse of I am low on fuse. It isnt that big, just a straw filled with smoke formula.

Are you sure that would work Zero? Wouldn't the fuse just burn through it all into the salute?

I will if you have 2 fuses, one into the smoke and one at the end of the smoke into the explosive.

CTR

Heh...Like in that movie oceans eleven....That was pretty sweet though....I may have to give that a test....

You could do without the second fuse entirely if you built it right. Just leave the fuse hole in the explosive open and touching part of the cast smoke compound. It would likely go off while part of the smoke compound was still burning, scattering burning chunks about and increasing the overall coverage of the smoke.

~Zero

Be careful becuase it might land on something flammable and burn a house or a car or whatever is in the way.

Reminds me of using WD-40 for fireballs. Near by objects set ablaze.