Hello fellow totse users!
The following is COMPLETELY hypothetical and therefore did not happen and probably never will.

"I" have a special weed grinder that collects powder in the bottom compartment, this type of grinder is referred to as a "pollenator" on various internet sites so i will call it that from now on.

Once i have grinded an 8th or a quart of ganja , i am left with the nice, ready to smoke weed in the grinding section. However, the powder that falls through the screen of the "pollenator" is, in my opinion, too fiddly and inconvenient to smoke in the usual ways, and so, i would like to make some nice hash from the powder left over.

Do any of you have any simple ways to make some nice solid from this hash powder?

Thank you

y nut just snort it duh!!!!!!!!!

i would like sensible replies from now on thanks

a keif /w extra holding area? or what?

its a grinder that seperates the smokable, grinded weed, and the really fine powder goes into a seperate compartment.

whats the easiest way to make hash from that powder?

i have one of those grinders... turn on any desk lamp you have in your room while you do all this...
the way that i do it is get a cig pack, take the plastic bit from the outside(the see through film) cut out a rectangle from a flat edge, size depending on how much thc you got...
fold this in half so theres a crease like a rolling paper...then whap the crystals along the crease, fold over so its all closed in and use a knife to sort out the thin bits/thick bits so its all relatively the same thickness.
then press against the lamp i told your ass to turn on, not directly onto bulb, if it has a metal covering this would be ideal... keep pressing it against the hot metal covering for 20 seconds on each side, about 2 times on each side. if you have to press against a light bulb, then wrap more layers of film, or press for half as long at a time.

open up the film and you should have some loosely compressed greeny/browny substance... keep folding the film where the stuff is in different ways so that the hash gets thicker but smaller... and heating it on the lamp between each folding of the hash
after a while you should be left with a pipes/bongs worth of hash...maybe a joint if your into that.
good luck

also look on youtube for "hash making" theres lotsa vids there...

cheers for that mate
i will try that in a bit and hav a bong later :D
lol thanks