The proper way to shoot namebrand OC is to remove the wax coating, crush dissolve, filter, and shoot, correct?

Also, how do you do an IV prep for OC's and morphines that gel up?

Thanks

I don't think you even need to remove the coating. I've never personally shot it, only snorted it (but I do have quite a lot of experience in shooting H), I've seen it shot and they didn't remove the coating and they were fine. If you want, take it off but other than that, yeah crush, filter draw it up and shoot. It's just like shooting anything else.

^You have to remove the coating.

I never did this, but if I was to shoot it up again I would double filter it.

Everytime I slammed OC my arm would bruise relativley badly compared to other substances.

The coating will clot your veins remove it before melting down and use a good filter clean needle. All in all injecting pills is a bad idea.

I would say all in all injecting pills is a bad idea but at least it's the only thing you can shoot that's FDA approved and not some street skag with only God knows in it. Anyway, you do have to remove the caruba wax coating and for the pills that gel up there's a method you can use but I've never tried it and can't even think of the name right now. If you've never shot OC just make sure you start with a small dose beforehand to assess your tolerance.

Stay safe,
Bos

if you filter through a wheel you have no worries...


you could crisp the "gel up" ones, but i'd suggest checking out that opiod board for the end all be all on that....


oh yea, 2 units per mg. thats important.

__________________
the road of excess leads to the palace of madness