This has already been discussed but I am asking again, since this is potentially dangerous if I fuck it up.

So I want to know what some good ratios with this shit would be. I have 1000mg 2ce coming soon, and I dont have a sensitive enough scale to measure it. What should I cut the 2ce with that will dissolve into a drink well? I believe stupid noob said that adding food dye helps avoid clumps of higher active sub density. Because you can see the over saturated areas. What is a foolproof way to mix it 100% even? Coffee grinder?

Sorry if this has been covered, fucking it up isn't an option.

idk, i don't like the concept of diluting it as a solid. if you put it into solution it's guaranteed to be evenly dissolved if you stir it and there's no clumps...

well depending on if its polar or non polar you could dilute it into water or ethanol...

you have a known amount of material, dissolve it into a known amount solvent and you can figure out a pretty accurate mg/ml dosage... a syringe would probably be your best bet for measuring out dosages accurately...

Yeah it is able to dissolve in water and ethanol. My only worry was that if i let it sit for a long time (which it most likely will) that the powder would settle and maybe cake to the sides of the container.

it shouldn't, not unless you heat the solvent up to get the 2CE to dissolve...

Ok, so as far as I understand if something is soluable in water, then it wont just un-dissolve. I would have to evaporate it to get the salts back right?

that, or make the solution really cold to get the solute to crash out...

It was actually me that first introduced it here. I read it on another forum.

What you do is mix your known amount of drug with an equal amount of dye. Then you mix that with a cut until it's a uniform color. Example: take 2 grams of 2C-B. Mix with 2 grams of Kool-Aid until it's a consistent color. Mix it with 16 grams of sugar until it's consistent to get 10 mg of 2C-B per 100 mg of powder.

if its dissolved in water i wouldn't think that it would just settle... some solutions will stay homogeneous, if your worried you could always just shake the vial before you measure out doses...

but yea try to make sure its as close to 1000mg as possible, they short you and you have weak doses, they accidentally gave you more and they will be stronger...

that sounds pretty straight and it's easier to distribute rather than mLs of solution...