So I have some keif in the bottom of my grinder, and I need to get high.

Unfortunatly I don't have any weed to throw it on top of, and was wondering if puting some on the end of a cig and lighting would be enought to get meh high?

maybe? just make a screen with a needle and some aluminum foil, its what I always do.

No. Cig filter sucks at lettin cannabinoids through. And if u rip it off then it will taste like buttcheeks and wont be able to hold that harsh smoke in.. just chase the dragon or lightbulb vape if you want to get the most of it.

Can you really smoke it off of foil?

the question is do u want aluminum vapor in your lungs? not really, but hey shit happens.

I mean make a screen for your bowl with al foil.

I wouldn't do it or anything, but it's an interesting idea. I guess if hot knives work, foil would too.

Lightbulb vape would be the best if you were going to do something like that.

if its sticky then you should be able to rub it into hash

http://en.wikipedia.org/wiki/Aluminum

Yes, aluminum vapors.....

never done this, but why cant you just take tobacco out of a cig, put it in a bowl, put the keif on top, and light up?

Because It would be very, very strong. A black and mild would work great though.

It's not that strong at all.. I've smoked cig tobacco out of my pipe probably 100 times, for kief, resin, or hash, or even when i just want a nicotine fix without heading outside into the cold.

It's not harsh, but then again I smoke 10 a day so for a solely weed smoker/occasional it might be too much.

Just scrape a little resin out of the bowl of your pipe. Heat up th inside of the bowl and use your finger nail and scrape down the sides of the bowl. Collect of your finger nail ball it up and put itover the hole in he pipe. then put the keif on top.

I've always heard I shouldn't roll a blunt with a black-and-mild. For some reason it sucks and I should avoid it all costs.


In my mind, it makes pefect sense, you have a built-in crutch, I mean... it beats a regular blunt any day, hands down.

Put the keif in the corner of a baggie, tie it tight, put the baggie between two quarters, and then press in a C clamp, or a vice, tighten as much as possible, and leave it for an hour.

Come back, open it up, and very carefully peel the plastic off and you will have a solid wafer of hash. Cut it up into small pieces and smoke it like you would weed.

this.

no... no... you could roll it into a ball of hash, you either need a small amount of heat to press hash(with some pressure), Or a lot of pressure, ie: a press. With kief from a grinder, It wouldnt be that good, youd need hash powder to get good hash.

Oh yeah, heat. When I press my keif with this method I forgot to add that I heat the quarter with a lighter, gently, not enough to melt the baggie, but still enough to transfer to the hash. Just barely warm it.

Try tipping the B&M cigar so that the crutch is facing straight up, with the opposite end facing down toward a sheet of paper. From the bottom of the cigar up to the crutch, lightly pinch and twist the cigar so that the tobacco falls out onto the sheet of paper. Do this until you have a pile of tobacco piled on the sheet of paper above an empty shell of a cigar. Blow into the crutch. Out will fly an inner paper which is thicker but lighter than the outside paper. Fill the empty outer shell of the cigar with the tobacco again, or with finely ground marijuana buds. Drop the crutch onto a table a few times to settle the newly packed plants. Spark.

I have actually never filled a shell with bud before. I think I might try to do it tomorrow night.

Put the keif in the corner of a baggie, tie it tight, put the baggie between two quarters, and then press in a C clamp, or a vice, tighten as much as possible, and leave it for an hour.

Come back, open it up, and very carefully peel the plastic off and you will have a solid wafer of hash. Cut it up into small pieces and smoke it like you would weed.Its going to need to be some pretty pure keif(no leafy matter in it) Or it wont clump.

i use a iron on very low heat and layer foil over the baggie. Then I use the iron as a press. Try it sometime if you have more than just a litlle to press.

Lay a bed of ashes from a cigarette in your bowl, a tap or two should be fine. Put the keif on top of the ashes and way to go.

i always collect kif, and there's a few ways i smoke it.

you can use a vape. i use a light bulb. it helps to make a long "spoon" out of paper to drop it all in a nice little pile in the bulb rather than let it scatter.

you can buy some legal herbs (or use tobacco) and roll it into a joint. this is somewhat less effective.

you can press it into a nice, solid chunk in a number of methods. the quarter/vice method works. i made a press out of lego's (if you really want to know how, i can post instructions), but later made on a rapid prototype printer out of ABS plastic. once pressed you can just drop it into a bowl.

another thing to do after it's pressed and stick it to the end of a pin (carefully), and let it burn, like incense, into a bottle or cup, somewhere you can catch the smoke, and then when it burns out, inhale the smoke in the bottle/other.

or just make an aluminum screen and a bowl. a bic won't get aluminum hot enough to release harmful vapors.

How long will it take to get thc drops if I just put keif in a small container with the glycerin then heat and shake the container?