SWIM hasn't smoked M before.

SWIM was thinking of using a pyrex test tube w/ a stand and clamp for the tube. on the top SWIM will put a piece of rubber bike tire tube over the opening secured w/ rubber band, then poke two small holes in the rubber and insert two small plastic straw or pen pieces into the rubber (draw tube and carb). is this a working pipe?

now, a smoking question:

SWIM should b gentle w/ the heat, right? just melt the M hcl in the tube, not directly flame it, a la crack, right?

assuming pretty good purity, how much M hcl would SWIM need to place in tube to b an effective, but not excessive dose?

forgive SWIM's unlearned Q, but SWIM has always been a huffer of pwd. but wants to try that increased onset of action route! RUSH isn't just a great band y'know (speaking of which, anyone hear of the new year's Leifson arrest?).

lord

give me patience

they know not what they say

kirb, SWIM thought he said as much, which is why he posted the question. let me b a little more blunt;

How do u smoke meth?

now, just because SWIM hasn't smoked before, doesn't mean SWIM is ignorant of correct organic chemistry so, feel free to b as technical as u wish! (humph, SWIM's no dummy! enlightenment comes through intelligent curiosity/ questioning; one of life's great pleasures is meeting of minds for discourse).

please, help.

what is the procedure w/ the lightbulb that SWIM has heard mention of?

nevermind, SWIM had to learn solo.

found a site to help.

castitas.com

using the bulb....with a nail....tap a hole in the side of the bulb...next..bust out the electrical connection and remove it all...leaving just the center hole .....drop in yer goodz through the tapped in the glass hole...heat gently...makes my mouth water just thinkin of hitz...lmao..use a pen tube to inhale through the tapper hole and use the electrical end as the carb and handle.....

u can always tell a tweekers house.....they aint got any lightbulbs to be foundin any lights.....and all the neighbors outside lights are gone too.....



BlueCollarTweeker bids you a fair tadoooo....

PUFF ON!

hit 1 fer me pleeeeeze

i hit the foil

take a strip of foil 6 inch long and few inches wide. fold long ways a few times. dull side up, crease long ways. put shard on one end, pass lighter underneath quickly to melt and stick onto foil. tilt foil with shard on up side. hold the other end, stick tube in mouth an inch over shard. pass lighter underneath it so it starts to smoke. you have to be kind of quick. if you taste it too strong, remove the lighter for a few seconds, if you barely taste it at all, you will get a small hit, or you can leave lighter under it a bit more. oh, and inhale through the tube.

smoke or IV is the only way to do meth. well, hot railing is good to do occasionally.

[This message has been edited by jack (edited 01-11-2004).]

put about .1g or less in pipe, heat lightly until liquid and slowly smoking, dont get too hot or u'll burn it, puff on it, and be sure to gently roll pipe side to side spreading out the M, need anything else, just ask

Ok amine here is the best way to use a light bulb; 100 ge clear is the best or the heavy watt oven bulb. take side cutters and fold up the round metal at the base, take neddle nose pliers and twist that off, take hemos and get the wire guts out, make sure you get them all. now that guts are out take 20oz soda bottle top and put hole that a straw will fit in. now put this on the screw base of bulb, make sure you don't break the bulb from the base now. with straw sticking in soda top take a torch a gently put to side of bulb and start to gently blow in straw, get ready because it will pot and a hole will be blown in the side of the bulb. let it cool and then take the soda top off and shake out any glass. now take electric tape and put inside the base of the bulb, now put soda top on and tape it on.

Now load your goods from the hole in the bulb and proceed as have been instructed.

roll that bowl!!

later, 46

i use a huge glass dick with condenser globes ribbed throughout the stem. I smoke no less then 3.5 grams at a time in my thick pyrex bowl. I prop the bowl in a oil bath at just over 200 degrees f. Then I wait patiently for the solid to change to liquid, then to gas You can play around with different temperatures depending on how fast you want your product to Vaporize. I blow hits out like a fog machine.

I am very much loyal to the foil. I take great pride in representing the old school heads even though I am a mere 28 years old. The best is smoking off foil through a water perculator which condenses your fine vapor. I also use a little Denatured torch with just a blue flame.

Shout out to the Old School and all the Filipinos Repn the Foil.



[This message has been edited by 0.S. Sparkel (edited 01-12-2004).]

wow, thanx for the info all.

so, since nobody commented on SWIM's initial Q on his test tube pipe design, should SWIM assume the test tube jammy won't work?