......has flipped a bitch? Friend says his first balloon broke about 3/12 hrs into his adventure, But! he saw it break and had ballons and tape right there with him so it was only open for about 5 seconds 'til he had another ballon strap on tight. Now 6 hrs later his ballon has started to head into the bottle.....well it's in there about 2 inch's.

some more info from friend:

started @ 130 degrees

*2hrs in @ 140

-31/2 balloon break and open for 5 seconds-

*51/2hrs in @ 155- off heat for 15 min.

*6hrs in ---UPDATE--- he just cut off ballon fearing that it might pop so rather then wait and see he went in with ballon and tape ready and again has exposed the cook for another 5 seconds tops-----now the new balloon is erect as it should be----so I guess the new question is, will the two 5 sec. exposures pose any significance to the outcome?

More info:

ratio 4.5g I2- 3.5g E- 3g RP- 9 ml dh20

ummm swim dont see how, swim puts his tube end in a sandwich baggy, with about 1-2 ft of tubin, less it gets over 350 phosphen gas is not created ( im guessin at that due to reading on dangers)... swim believes no noteable diff will be seen or felt. swims with ya on this, swimms gonna dreammmmm tonight. took extra sleepin pill tonight, good luck and dont sweat it, its all good,

ps , pee on da ballon less ur really hot cookin for speed.



roll alone...... rnx57

Swim has heard that putting something between balloon and neck of rxn vessel will prevent the balloon from being sucked into the rxn vessel(a stopper and a piece of glass tubing, or a piece of PVC pipe duct taped to the neck of the rxn vessel).