swinc would like to know if these would be considered for ve-8 extraction technique.

Ingredients : 25mg Ephedrine HCL

Non Medicinal Ingredients : Calcium Carbonate, Cellulose, Magnesium Stearate, Calcium Phosphate, Starch, Silicon Dioxide.

NO GUAFENSEIN.

thanks bunches in advance for any guidance!

nymph

Hey Nymph...Swirh is by no means an authority...but in his limited exp..thus far with the STE...those listed ingredients do not raise any red flags in his memory.. He recently tried the 120 tombstones and had some questionable results... But if that is all they have in them then IMHO they should be OK. Maybe another opinion would help reassure you. But the STE is leaps and bounds easier and quicker than the last way that Swirh was utilizing. Without the cleaning tho...one mite be prepared to "practice" a few times, ya know? Hope this helps...

Oh yeah, this may be off topic; but Swirh is in a chatty mood tonite and HAS to share this. Imagine some veiny "lightning bolt" looking action under glass (or rather in it) when things start reforming after a good heating. Little did Swirh realize (until closer inspection) was that a couple of my-newt specks of some red velvet cake mix got (don't ask, lol, it somehow got there after Swirh was eating some closeby and... the rest is history) loaded into the glass receptacle... When the heat was applied, everything turned some funky bloody red. Swirh not being the type of wasteful person--not to mention this vintage was something a person would just nut over (or gender equivalent)... He pursued the process of alternating expansion/contraction (hehe) until this very "different" taste reached a level that even Swirh could not tolerate. MORAL: Betty Crocker makes shitty cut, lol. It would break Swirh's heart to lose that (at that exact moment since that was the last and he did not want to soak and reanimate).

But anyhow, good luck and Swirh wishes you the best...

Cracknymp if you are haffing difficulties

with VE's or any other methods for information you should try also

using a H20/gasoline pull for anything

with silicon dioxides,or titanium starch

fillers. like take whatever amount of

pill mass you dreemin about put about

3 cups of regulaR in there with powdered

PsoofeDz, shake for 5 minutes. your fillers

and gooks should become suspended in the gas

then remove all the gas which if before you

do this the psufos should not dissolve in the gas but will be left at the bottom of the container. discard all gas save wet

pill massat the bottom of the container

and dry it. take some of this and test

to see whether it is pure or burns black

when heated(make sure it is totally dry though. if it does burn a little black

but not completely like charcoal black,

then add water to your powder mass and

get all that shit to dissolve in the water.

filter this same water with dissolved

psuco through a 4-stacked coffe filter(s)

once twice or howevere clean you like it.

I just did a 1/2 cup acetone,1/2 cup water

extraction on some shit filled tabs and

filtered this 8 times till my water/acetone

was clear as water. when I did a burn test

on glass with this mass it bubbled slightly

at first then liquified, then smoked but

it NEVER turned black, this was some of the

cleanest psudo I have ever seen.

try experimenting with polar+non-polar

pulls, non-polar+water pulls, and

water+gasoline pulls, remember psuedo

will dissolve easier in plain water than

anything else,silicons and heavy adulterants

should become liquid suspended in gasoline.

VE's STE will work good on these pills.