About
Community
Bad Ideas
Drugs
Ego
Erotica
Fringe
Society
Technology
register | bbs | search | rss | faq | about
meet up | add to del.icio.us | digg it
Go Back   Community > Science > Laboratory Tips
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Laboratory Tips Safety proceedures, test reagents, drilling rubber stoppers, bending glass tubes, etc. Contributed to by chemists.

Closed Thread
 
Thread Tools Display Modes
  #1   Add NeverSleepy to your ignore list  
Old 2003-02-24, 14:25
NeverSleepy NeverSleepy is offline
Regular
 
Pamona California USA Send a message via ICQ to NeverSleepy
Default

Crush ANY pills that only contain pseudoephedrine as the active ingredient

Boil pill powder in 40% lye water without letting any steam evaporate or you will lose pseudo

Continue boiling until color goes from yellow to black [few hours]

Add np, shake then pull off

Repeat np pull

Add the two np pulls together

Wash np with h2o twice

Dry np with calcium chloride [damp-rid]

Evaporate np until only pseudo oil remains

Freeze the oil, scrape then do what you want with it before it melts



FUCK THE STB and E_GULL and W_A/B and TURPS_CURE and STEAM_DISTILLING

THIS GIVES +95% yeilds of 100% pure escential oil in just a few hours useing cheap, easy to get chems [lye/h2o/damp-rid/kingsford]



  #2   Add gottagogo to your ignore list  
Old 2003-02-24, 19:25
gottagogo gottagogo is offline
 
Default

[quote]Originally posted by NeverSleepy:

[b]Crush ANY pills that only contain pseudoephedrine as the active ingredient

Boil pill powder in 40% lye water without letting any steam evaporate or you will lose pseudo

So you're going to boil water for a couple of hours without letting any steam escape. I doubt it. Luckily, pseudo is not as volitile as meth and perhaps SWIM is a little off base on this one. Also, maybe you are forgetting about the drymatrix formulations that have an additive used specifically to run up into the non polar layer (and mess up your rxn.) if it is not removed first. Maybe you should use the bleach test to determine the purity of your pseudo. As for newbees and inexperienced individuals, if tetra is available to you, it is by far the easiest and SWIM believes its the best all around cure available.



FUCK THE STB and E_GULL and W_A/B and TURPS_CURE and STEAM_DISTILLING

THIS GIVES +95% yeilds of 100% pure escential oil in just a few hours useing cheap, easy to get chems [lye/h2o/damp-rid/kingsford]

SWIM in no way believes that you can achieve this kind of yield from this kind of extraction. If there are any chemists out there please tell SWIM what they think.

  #3   Add NeverSleepy to your ignore list  
Old 2003-02-24, 22:02
NeverSleepy NeverSleepy is offline
Regular
 
Pamona California USA Send a message via ICQ to NeverSleepy
Default

Go spend a few bucks and give it a try pussy.

The "base boil" releases the pseudo from whatever chem is holding it the water so it can be extracted via np. I just vaporized some of this oil on foil and it didnt even leave a trace of anything behind.

  #4   Add tryptamine to your ignore list  
Old 2003-02-25, 00:45
tryptamine tryptamine is offline
Regular
 
British Columbia Canada
Default

so when you add the lye water to a pill powder that has carboxomethylcellulose and the mass turns into gell and you boil this and it burns does it still work.
  #5   Add NeverSleepy to your ignore list  
Old 2003-02-25, 02:11
NeverSleepy NeverSleepy is offline
Regular
 
Pamona California USA Send a message via ICQ to NeverSleepy
Default

Yes



  #6   Add t3knology to your ignore list  
Old 2003-02-26, 02:52
t3knology t3knology is offline
 
MA
Default

sorry for the n00b question, but what is NP?
  #7   Add DrY.R.Head to your ignore list  
Old 2003-02-26, 03:10
DrY.R.Head DrY.R.Head is offline
Regular
 
Deep in the rabbit hole USA
Default

NP solvent means a non-polar solvent. For example; benzine(Colmen fuel), toluene, petroleum distillates (white gasalines)

and ethers.

NP's can be used to pull oils out of solutions. As decribed above.
  #8   Add tryptamine to your ignore list  
Old 2003-02-26, 04:01
tryptamine tryptamine is offline
Regular
 
British Columbia Canada
Default

Colemans fuel is not benzene, it is petroleum ether. It has crappy rust inhibitors in it so you should distill it before use.
  #9   Add frankz81 to your ignore list  
Old 2003-03-04, 04:58
frankz81 frankz81 is offline
 
australia
Default

how do u use the tolulene to 'pull' out the oil?? do u drain in or freexe n scrap it?

thanks

i am very new to this and need all the help i can get,i am still experimenting as i am sure most of u were in my position unless being shown,if anyone wants to email me with the most simplest way (i didnt do chemistry) id appreciate that soo much!

  #10   Add junglizt to your ignore list  
Old 2003-03-05, 09:54
junglizt junglizt is offline
 
Default

JUST A QUESTION?? I HAVE LOOKED FOR TOLUENE ALMOST EVERYWHERE. ALL I CAN FIND IS XYLENE. IT IS USED IN PLACE OF TOLUENE CUASE OF IT'S SLOW EVAP RATE. IS IT ADVISABLE TO USE THIS???
 #11 
Old 2003-03-05, 13:19
gottagogo gottagogo is offline
Regular
 
Default Re: NEW FUCKING EAZY FREEBASE PSEUDO EXTRACTION!!!

jung, dude lay off the caps, please. The answer is almost universally yes. Xylene can be substituted for toluene in every case involving OTC pill extractions I have ever read. That doesn't mean it is without exception, but it is doubtful you will run into any problems with xylene.

The guy with the broad "how to make meth" question. Try to figure out one thing at a time. Start with something really easy to do- - say pulling good, clean red phosphorous from a shitload of matchbooks - - like maybe the store brand from the drugstore that sound like painting your wall with a mixture of blue and yellow. Look for info on the use of acetone and Hcl. to fascilitate this operation, then step up to the next course. Do not take information or procedures lightly or as automatically accurate just because it appears in print. If someone posts about the "super fast, super easy" method for anything and you cannot find substantial confirmation from known names (or those with a lot of posts to their credit) then its probably not all its cracked up to be and should definitely be avoided by beginners desiring confidence building success, no matter how small.

As for neversleepy, you really disappoint me. I didn't make the connection the other day when I read your little taunt, but its all the more reason to check your mail. Trip. took it easy on you. But you, me, and everyone else who knows anything can tell the difference between a talker and a doer.

For those who know very, very little, avoid this guys advice. Maybe he's right, maybe he's not, but for sure there are more reliable sources out there.

Use your brain. It's not too busy.
 #12 
Old 2003-03-05, 14:53
NeverSleepy NeverSleepy is offline
Regular
 
Default Re: NEW FUCKING EAZY FREEBASE PSEUDO EXTRACTION!!!

Yea, guess I forgot to tell you totse fools that this was just some made up bullshit.
 #13 
Old 2003-06-08, 01:31
darkchild darkchild is offline
Regular
 
Default Re: NEW FUCKING EAZY FREEBASE PSEUDO EXTRACTION!!!

toluene is available at most print shops. they use it as a print roller cleaner and usually have a couple of 55 gallon drums around.
 #14 
Old 2003-06-08, 07:09
crashnburn crashnburn is offline
Regular
 
Default Re: NEW FUCKING EAZY FREEBASE PSEUDO EXTRACTION!!!

good advice gottagogo for us new bees much appreciated...not that im that stupid to jump and do anything i read the first time without doing some research first tweek on brother.....
Closed Thread

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode
Hybrid Mode Switch to Hybrid Mode
Threaded Mode Switch to Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump

 
To the best of our knowledge, the text on this page may be freely reproduced and distributed.
 

totse.com certificate signatures
 
 
About | Community | Bad Ideas | Drugs | Ego | Erotica | Fringe | Society | Technology
Hot Topics