ok, my question, if i had my autoexec.nt witch says.

""

@echo off

REM AUTOEXEC.BAT is not used to initialize the MS-DOS environment.

REM AUTOEXEC.NT is used to initialize the MS-DOS environment unless a

REM different startup file is specified in an application's PIF.

REM Install CD ROM extensions

lh %SystemRoot%\system32\mscdexnt.exe

REM Install network redirector (load before dosx.exe)

lh %SystemRoot%\system32\redir

REM Install DPMI support

lh %SystemRoot%\system32\dosx

REM The following line enables Sound Blaster 2.0 support on NTVDM.

REM The command for setting the BLASTER environment is as follows:

REM SET BLASTER=A220 I5 D1 P330

REM where:

REM A specifies the sound blaster's base I/O port

REM I specifies the interrupt request line

REM D specifies the 8-bit DMA channel

REM P specifies the MPU-401 base I/O port

REM T specifies the type of sound blaster card

REM 1 - Sound Blaster 1.5

REM 2 - Sound Blaster Pro I

REM 3 - Sound Blaster 2.0

REM 4 - Sound Blaster Pro II

REM 6 - SOund Blaster 16/AWE 32/32/64

REM

REM The default value is A220 I5 D1 T3 and P330. If any of the switches is

REM left unspecified, the default value will be used. (NOTE, since all the

REM ports are virtualized, the information provided here does not have to

REM match the real hardware setting.) NTVDM supports Sound Blaster 2.0 only.

REM The T switch must be set to 3, if specified.

SET BLASTER=A220 I5 D1 P330 T3

REM To disable the sound blaster 2.0 support on NTVDM, specify an invalid

REM SB base I/O port address. For example:

REM SET BLASTER=A0

""

and changed THE CONTENTS to something like

"C:\windows\system32\235jf05jf.exe"

what would happen?

[This message has been edited by smokeymcpot420 (edited 12-27-2004).]

plese move to T&T.