i'm new to the whole dope thing and i was interested in learning how to blow my own glass dick any help would be appreciated.

I dont think you can unless you have access to a glass blowing shop. It takes alot of skill to blow glass, I saw it on t.v.

Actually if you can get a glass tube (like the tubes that cigars come in, not sure what brand though) you can make a pipe using a propane torch (available at hardware stores or Wal*Mart). My friend does it, although I've never seen it done. Try searching google for some tips on it.

It also takes ovens of differing heats, (ones 2200 degrees, thats all I remember). This kid that lives over here's dad is a famous glass blower and he's taking after him. He can blow his own pieces, so hes been selling them for a while now. They aren't the greatest but it's still cool to smoke out of a piece your buddy made.

[QUOTE]Originally posted by arecpadgett:

Actually if you can get a glass tube (like the tubes that cigars come in, not sure what brand though) you can make a pipe using a propane torch (available at hardware stores or Wal*Mart). My friend does it, although I've never seen it done. Try searching google for some tips on it. [/QUOTE

I think the cigar is a garcia e vega that has the glass tubes, not sure though

Just buy one they're not that much ($10 for a 8 inch glass pipe with swirls and shit ) so ill go with paying for one b4 i woould make one lol

late

quote:Originally posted by JSM420:

blow my own glass dick .

hmmm.. i never once heard a pipe referred to as a dick, and putting the blowing part in there didnt help out the fact that i can be immature..hmm good luck anyway.

quote:Originally posted by I_Tweak_Too:

hmmm.. i never once heard a pipe referred to as a dick, and putting the blowing part in there didnt help out the fact that i can be immature..hmm good luck anyway.

yes, I almost went for the 8th grade humor but it was too obvious.

meth pipes are often called dicks

Making a meth or crack pipe is easy. Get a test tube (pyrex is best), a propane torch, and a cork. Turn the torch on medium high and put the cork in the tube. Rotate the end (the non-cork end!) of the tube in the flame slowly. The glass will soften and the hot air trapped inside will make the end start to balloon outward. Carefully rotate and don't let the tube get too hot until it's the size you want, then just hold one spot on the flame and it will burn through. That's the hole where you put you shard or brillo.